1. Connect fiber optic jumpers or tail fibers from the fiber optic terminal boxes at both ends of the same pair of fibers to the SC port of the remote transceiver.
2. Connect the UTP jumper from the network device to the RJ45 interface of the single fiber transceiver, which can adapt to straight or cross lines.
3. Connect the DC plug of the power adapter to the DC socket of the fiber optic transceiver, and then plug the AC plug of the power adapter into the AC socket to connect the power.
4. After connecting the power, the POWER light of the fiber optic transceiver will light up, and the other indicator lights will flash in sequence according to the self check sequence.
5. After the self check is completed, the working status of the transceiver's electrical port will be determined based on the electrical port status detected by the fiber optic transceiver to connect with the network equipment. If the docking device cannot be detected (such as the docking device not being turned on, etc.), the status of the transceiver port is adaptive, that is, uncertain, so the TXLINK and TX100 indicator lights are not on. And since the fiber optic port has been set to 100M full duplex state, the FX100 and FXFDX indicator lights will be on.
